佳寶樹脂股份有限公司
Insole
Insole
\ Details /

| Product Introduction

Product Description
Applicable products

  • All kinds of shoes, sports shoes, boots, special shoes, shoes ....
Operation method 
  • Do not add gauze, direct rub LATEX or yellow paste can be used.
  • Can be sewn directly on the upper, especially in this product with injection molding shoes, to prevent flash material, cost savings.
Company code

 
  thickness width
CP-10 1.0mm ± 0.05mm 36" or 40"
CP-20 2.0mm ± 0.1mm 36" or 40"
CP-30 3.0mm ± 0.1mm 36" or 40"
Production thickness 1.0~3.0 mm Use: Non-woven fabric
 

F-class

★This series of products hardness, toughness is more moderate, you can bend freely, so improve the comfort of the product.
F-class thickness width
CP-F080 0.8mm ± 0.05mm 36" or 40"
CP-F125 1.25mm ± 0.1mm 36" or 40"
CP-F300 3.0mm ± 0.1mm 36" or 40"
Production thickness 0.8~3.0 mm Use: Non-woven fabric
 

E²E -class

★This series of products hardness, toughness stronger, the sole can maintain the shape of shoes,  suitable for special shoes type, or have a higher stereotyped demands of the shoes, products. Example: golf shoes, soccer shoes, skates, baseball shoes.
★Has high rigidity, high tensile strength, good heat deformation.(heat deformation temperature 100 ° C)
E²E -class thickness width
CP-C08E 0.8mm ± 0.05mm 36" or 40"
CP-C08E² 0.8mm ± 0.1mm 36" or 40"
CP-C12E 1.1mm ± 0.1mm 36" or 40"
CP-C30E 3.0mm ± 0.1mm 36" or 40"
CP-C30E² 3.0mm ± 0.1mm 36" or 40"
Production thickness E² 1.0~3.0mm
E 0.8~3.0 mm		 E²two side non-woven
E: single-sided non-woven